EN
1. Defrosting
The defrosting of the wine cellar is done automatically; no manual operation is
needed.
2.Replacing the LED lamp
The lamp uses LED as its light source,featuring low energy consumption
and long service life. If there is any abnormality,please contact the customer
service.See CUSTOMER SERVICE.
WARNING!
LED
LED
Parameters of LED lamp:
Voltage12V; Max power:2X2.5W
3. Non-use for a longer period
Unplug the power cord.
Clean the appliance and door gaskets as described above.
Keep the door open to prevent the creation of bad odours inside.
4. Moving the appliance
1. Remove all bottles and unplug the appliance.
2. Secure shelves and other moveable parts in the wine cellar with adhesive tape.
3. Do not tilt the wine cellar more than 45° to avoid damaging the refrigerating system.
The way in which wines continue to mature depends on the ambient
conditions.The quality of the air is therefore decisive for preserving the
wine. An activated carbon lter has been tted inthe lower area of the rear
wall of the appliance to through put remains at an optimum quality.
Notice
We recommend that you replace the lter once a year.Fiters can be obtained from your
dealer.
Take the ter by the handle.Turn it to the left and
remove.
Insert with the handle in a vertical position.Turn it
to the right and insert.
Do not replace the LED lamp yourself. It must only be replaced
by either the manufacturer or the authorised service agent.
Care and cleaning
23