Gymrex GR-MG 58 Manual De Instrucciones página 25

a) Install the left training arm (4) to the mounting plates of the left side frame (1).
To do this, align the hole axes. Pass the rotating roller through the hole. Secure
the arm on both sides with bearing washers and M8x20 screws.
b) Install the right training arm in the same way.
c) Fix the training load holders (5, 6) to the training arms. To do this, insert the
holders into the middle hole axes. On the inside of the arm, attach with an M8
washer and M8x30 screw. Finally, fix the cap.
f) Fix the left and right (8, 7) load holder the side frames of the machine. Fasten
with M8x25 screws, M8 washers and M8 nuts. Guide the screws from the
inside of the side support frames.
STEP III
a) Place the seat support frame (17) on the main frame (13). Fasten with
screws, washers, locknuts and sliding sleeves.