Gymrex GR-MG 58 Manual De Instrucciones página 23

a) Connect the machine bases (10, 11) with front (14) and rear (9) fasteners. For
this purpose, use M12x135 screws, M12 washers and M12 safety nuts. Align
the axes of the base and fastener holes. Slide the washer onto the fastening
screw. Insert the prepared assembly into the outer axis of the hole. Secure
with a washer and nut from the inside. Repeat the procedure for all holes.
b) Attach the machine side frames, i.e. the left and right frame (1, 2), to the rear
fastener (9). Use M12x75 screws, M12 washers and M12 locknuts. Align the
fastener and frame hole axes. Slide the washer onto the fastening screw. Insert
the prepared assembly into the outer axis of the hole. Secure with a washer
and nut from the inside. Repeat the procedure for all holes.
c) Attach the main frame (13) to the front fastener (14). Use M12x135 bolts, M12
washers and M12 locknuts. The installation procedure as the same as for
connecting the rear fastener with frames (see above).
d) Fasten the upper part of the main frame (13) to the side frame stabiliser (12)
with M12x135 screws, M12 washers and M12 locknuts. Guide the screw from
the outside.
e) Attach the side frame stabiliser (12) to the left (1) and right (2) machine
frames. For this purpose, use M12x135 screws, M12 washers and M12 safety
nuts. Guide the screw from the outside.