Idiomas disponibles
Idiomas disponibles
4. If the code fails, go through steps one to three
again. If the code works successfully, lock the safe.
5. When you open the safe in the future, enter the
security code, followed by the
knob.
6. If an incorrect security code is entered three times,
the safe will beep five times (if the sound is turned
on) and the red light will flash five times, resulting
in the safe being automatically locked out for 60
seconds before you can try code again. The safe
will beep one time (if the sound is turned on) and the
green light will flash once when the lockout period
is over.
7.
If an incorrect security code is entered one
additional time the safe will beep five times (if the
sound is turned on) and the red light will flash five
times, resulting in the safe being automatically
locked out for five minutes before the code can be
tried again. The safe will beep one time (if the sound
is turned on) and the green light will flash once
when the lockout period is over.
8. Write down safe's combination and keep this
information in a secure place, away from children,
not inside the safe.
LOCKING THE SAFE
To lock the safe, close the door and turn the knob
completely to the left to the 12:00 position.
NOTE: Because the locking mechanism is
deactivated for approximately three to six
seconds after the combination is entered,
wait a minimum of six seconds from the time
the combination is entered to lock the safe.
Also, when locking the safe, always make
sure the knob is turned completely left to the
12:00 position. If the knob is not turned to the
12:00 position during the locking process, the
mechanism will not lock.
PAGE 2 OF 9
USAGE CONTINUED
BATTERY REPLACEMENT
key, and turn the
This safe uses four AA batteries.
To replace batteries, open battery compartment on
back of door by pushing tab. Remove battery carriage
and insert batteries. Then, replace battery cover.
TURNING THE KEYPAD SOUND OFF/ON
Safe comes with the beeping sound turned on.
Turn off the beeping sound of the keypad by pressing
the
To turn the beeping sound on, press the
SELECTING A LOCATION
The safe must be mounted to a wall stud and to a
permanent shelf or the floor. For optimal safety and
security, the safe should be installed in an isolated, dry,
secure area.
SECURING THE SAFE
NOTE: Do not mix old and new batteries. Do
not mix alkaline, standard or rechargeable
batteries.
NOTE: If the batteries are low, the yellow light
will flash when you start to enter code.
key.
WARNING! The safe should always be kept out
of reach of children.
CAUTION! This safe must be mounted to a wall
stud and to a permanent shelf or the floor.
Failure to do so will compromise the safety and
security of the safe.
CAUTION! The safe needs to be in an upright
position for the locking mechanism to function
properly. Failure to mount the safe in the
correct upright position will compromise the
safety and security of the safe. (See Figure 1)
Figure 1
key again.
0721 IH-6731
