Makita 9556NB Manual De Instrucciones página 7

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (handle)
005804
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing or removing wheel guard
1
3
2
005805
1
3
005807
CAUTION:
When using a depressed
•
wheel/Multi-disc, flex wheel, wire wheel brush,
cut-off wheel or diamond wheel, the wheel guard
must be fitted on the tool so that the closed side of
the guard always points toward the operator.
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees. Be
sure to tighten the screw securely.
All manuals and user guides at all-guides.com
1. Wheel guard
2. Screw
3. Bearing box
1. Wheel guard
2. Screw
3. Bearing box
2
center grinding
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc
1
2
3
001070
WARNING:
Always use supplied guard when depressed center
•
grinding wheel/Multi-disc is on tool. Wheel can
shatter during use and guard helps to reduce
chances of personal injury.
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
005917
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing diamond wheel
(optional accessory)
CAUTION:
Always install the wheel guard before installing the
•
diamond wheel.
When mounting the wheel ensure that the arrow
•
(indicating the direction of rotation) on the wheel is
pointing in the same direction as the arrow for
rotation provided on the tool.
For model 9556NB, mount the inner flange onto the
spindle so that the side of the inner flange with the 20mm
diameter protrusion faces the diamond wheel. Place
the diamond wheel onto the inner flange making sure the
protrusion fits into the arbor of the wheel. Use the lock
nut to secure the wheel by placing it on the spindle so
that the flat side faces the wheel and screw the lock nut
7
1. Lock nut
2. Depressed
center grinding
wheel/Multi-disc
3. Inner flange
1. Lock nut wrench
2. Shaft lock