Procedure
2
If the LED on the receiver relating to channel 1 is not visible during program-
ming, it is necessary to check the outcome of the operation using the new
remote control
1
1 • Press buttons 1 and 2 of the radio control simultaneously for 5 seconds
2 • Release keys 1 and 2 of the functioning radio control
3 • Press key 1 of the new remote control.
4 • The receiver channel 1 LED flashes and then turns off.
Changing the battery
• Keep battery well out of reach of children. Call a doctor immediately if the battery is swallowed.
• Risk of explosion if new battery fitted incorrectly.
• Only use type CR 2032 battery to replace old battery.
• Always put the battery into some form of packaging for storage or disposal purposes. The battery
should not come into contact with other metallic objects as this may cause damage to the battery
or make it discharge or ignite.
• Damaged or flat batteries should be immediately disposed of correctly. Information on this is available
from the environmental authorities or your local waste disposal company.
• Do not dispose of battery with standard household refuse.
emote control
R
Sommer 4013
1. Pull out concealed keypad (D).
2. Take out battery (F) and replace
with new one. Ensure correct
polarity (+/-) !
Important to note!
Prior to re-assembling press button (B); LED (C) must light up - if it doesn't, battery has been fitted incor-
rectly.
3. Push concealed keypad (D) into stainless steel sleeve (E) whilst at the same time applying downwards
pressure (G).
emote control
R
Sommer 4014
1. Press down on the device lock (D)
and remove the remote control.
2. Take out battery (E) and replace
with new one. Ensure correct
polarity (+/-) !
Important to note!
Prior to re-assembling press button (B); LED (C) must light up - if it doesn't, battery has been fitted incor-
rectly.
3. Reassemble the remote control until the locking device (D) engages.
Distributed by KOOMANDO Srl - via Giovanni Paolo II, 45/C - Azzano Mella (BS) - 030 974 54 00 -
[email protected]
functioning until the channel 1 LED on the receiver lights up
- if no codes are transmitted for 10 seconds, the receiver exits the
programming status.
- to quit programming, press key 1. The channel LED turns off.
The new transmitter is coded.