Recommendations And Suggestions - Zanussi ZHC601X Manual De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Recommendations
EN
and suggestions
• The Instructions for Use apply
to several versions of this appli-
ance. Accordingly, you may find
descriptions of individual features
that do not apply to your specific
appliance.
• The manufacturer will not be held
liable for any damages resulting
from incorrect or improper instal-
lation.
• The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a
lower height, please refer to the
paragraphs on working dimensions
and installation).
• Check that the mains voltage
corresponds to that indicated on
the rating plate fixed to the inside
of the hood.
• For Class I appliances, check that
the domestic power supply guaran-
tees adequate earthing. Connect
the extractor to the exhaust flue
through a pipe of minimum diam-
eter 120 mm. The route of the
flue must be as short as possible.
• Do not connect the extractor hood
to exhaust ducts carrying combus-
tion fumes (boilers, fireplaces, etc.).
• If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances),
a sufficient degree of aeration
must be guaranteed in the room
in order to prevent the backflow
of exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
2
All manuals and user guides at all-guides.com
• In the event of damage to the
• If the instructions for installation
• Use only screws and small parts
• Connect the hood to the mains
Use
• The extractor hood has been
• Never use the hood for purposes
• Never leave high naked flames
• Adjust the flame intensity to direct
to guarantee the entry of clean air.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by the
cooker hood.
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
for the gas hob specify a greater
distance specified above, this has
to be taken into account. Regula-
tions concerning the discharge of
air have to be fulfilled.
in support of the hood.
Warning: Failure to install the
screws or fixing device in accord-
ance with these instructions may
result in electrical hazards.
through a two-pole switch having
a contact gap of at least 3 mm.
designed exclusively for domestic
use to eliminate kitchen smells.
other than for which it has been
designed.
under the hood when it is in op-
eration.
it onto the bottom of the pan only,
www.zanussi.com
Tabla de contenido
loading

Este manual también es adecuado para:

Zhc901x

Tabla de contenido