Gima TOBI MANUALE Manual De Instrucciones página 10

PERIODICAL MAINTENANCE CHECKS
The TOBI MANUALE suction equipment does not need maintenance or lubrication.
It is necessary to check functioning and instrument before every use.
Unpack the instrument and always check integrity of plastic parts, they might have been damaged
during previous use.
Close the aspirator outlet with your finger.
Press the foot and check vacuum functionally.
Type of fault Cause Remedy
1. No aspiration Jar Cap badly screwed down Unscrewed the cap, then
rescrew it correctly
2. No aspiration Lid seal not in its seat Unscrew the cap and insert the
seal properly in its seat
3. The float doesn't close If the cap has been washed, Insert the float into it's place
ensure that the float is not
partially detached
4. The float doesn't close The float it's covered by dirty Unscrewed the cap, leave the
material and put in on autoclave
5. Low suction Foam inside the jar Fill the jar to 1/3 full of ordinary
water
6. No aspiration due to Filter blocked Replace filter
flow leakage of mucus
Faults 1 - 2 - 3 - 4 - 5 - 6 None of the remedies has Contact the seller or GIMA
achieved the desired results After-sales Assistance
Service
If the overfill security system it's activated, don't proceed with the liquid aspiration.
If the overfill security system doesn't work there are two cases:
1° case – If the overfill security system doesn't work the aspiration will be stopped by the bacteriological filter
who avoid the liquid penetration inside the device.
2° case – If both the security system doesn't work, there is the possibility that liquid comes inside the device,
in this case return the device to GIMA S.p.A. technical service.
BEFORE EVERY CHECKING OPERATION, IN CASE OF ANOMALIES OR BAD FUNCTIONING,
PLEASE CONTACT GIMA S.p.A. TECHNICAL SERVICE.
GIMA S.p.A. DOES NOT GIVE GUARANTEE IF INSTRUMENT, AFTER THE TECHNICAL
SERVICE CHECKING, APPEARS TO BE TAMPERED.
10