Honeywell Home R200ST-N1 Instalación Y Guía De Usuario página 9

9. Visual & acoustic signals
Operating mode
Normal
Test
Alarm for smoke
Alarm silence
Low battery warning
Low battery/Sensor
fault warning silence
Sensor fault warning
Interconnected
alarm
End of life warning
Wireless
interconnecting
Alarm/Low
battery/Sensor
fault silence
If the alarm fails to operate or you have a "fault warning" the advice of the manufacturer
should be sought.
10. Wireless functions
Interconnect your alarms
a) Place the interconnected alarms as close as possible, not further than 5 meters apart.
Visual signal(flash)
1 x per 48 seconds
1 x per second (4 x)
1 x per second (4 x)
1 x per 8 seconds
2 x per 48 seconds
1 x per 48 seconds
2 x per 48 seconds
None
3 x per 48 seconds
Continuously on
HOW TO MUTE ALARMSOUND
ONLY AFTER RECOMMENDED ACTIONS HAVE
BEEN TAKEN
(see page 5)
- 9 -
Acoustic signal(beep)
None
1 x per second (3 x) /
pause of 1,5 seconds
1 x per second (3 x) /
pause of 1,5 seconds
None
1 x per 48 seconds
None
None
1 x per second (3 x) /
pause of 1,5 seconds
3 x per 48 seconds
None
Description
Device is functioning properly
Device is testing by press the
test/silence button for 3
seconds
Device is detecting smoke
If the Alarm signal is muted,
lasting for approx. 10 minutes
Battery is running low, replace
the smoke detector with a new
one.
If Low battery/Sensor fault
warning is muted, lasting for
approx. 8-10 hours
Sensor is not functioning
properly, see 11. Maintenance
Device received remote alarm
from other device.
The device is end of life,
replace the smoke detector
with a new one.
Device is sending or searching
for wireless signal
Press cover test/silence
button for 3 seconds