Pressure Testing; Using The Oven - Ooni Koda 16 Manual

Pressure Testing

The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of 1/2 psi (3.5kPa).
The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve
during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5kPa).
Operating instructions

Using the oven

Each burner is rated at 29,000 BTU/Hr.
To begin:
1. Make sure the oven has been leak tested and properly placed.
2. Remove any remaining packing material.
3. Light the burner using the LIGHTING INSTRUCTIONS below
Lighting instruction
To light the burner
Read all instructions before lighting
1. Make sure the control knob is in OFF position, and then turn the natural gas supply valve ON by turning it to
the ON position.
2. Push in and slowly turn the control knob anticlockwise until you hear a click and the burner ignites.
3. If burner doesn't light within 5 seconds, turn the knob OFF, wait 5 minutes and repeat the lighting.
8