Connect To Electrical Devices - CGM 2200I Manual Del Operador

Operating
1. Turn on the remote control switch.
2. Press the START button and hold for more than
0.3s for startup.
NOTE: Sometimes the generator can take a few
attempts to start in cold weather. If machine does not
start in the first 10 seconds, wait for 30 seconds
before attempting again.
If the motor turns a little then stops when you press
the Start button, it may indicate a low battery.
Charge the battery before operation or start by recoil
start.
7
After all above operations, the engine can be
normally loaded.
WARNING
It is prohibited to start or close the generating set
when the output terminal of generating set is
connected to an electric device and the electric
device is in "ON" state.
3.

Connect to electrical devices

Note:
1. Inspect power cord for damage before using.
There is a hazard of electrical shock from
crushing, cutting or heat damage.
2. Make sure that the generating set has been
properly grounded. If the electric devices
require grounding, the generating set must
ground.
3. Allow the engine to stabilize and warm up for
a few minutes after starting.
4. Make sure that the electric devices are in
"OFF" position.
5. Connect and start the electric devices.
6. Turn off all electric devices and disconnect
them from the generating set.
7. If the generating set supplies for several loads
or electric devices, start the smallest one first
and the largest one last.