CGM 2200I Manual Del Operador página 56

When starting engine, grasp the recoil starter handle
and pull slowly until resistance is felt. Then pull
rapidly to start the engine. When pulling the recoil
starter, firmly grasp the carrying handle to avoid
tumble of generating set.
WARNING
KICKBACK
Rapid retraction of the starter cord will pull hand
and arm towards the engine faster than you can
let go.
Unintentional startup can result in entanglement,
traumatic amputation or laceration, broken
bones, fractures, bruises or sprains.
WARNING
The engine starts time cannot exceed 15 minutes.
If the engine fails to start, allow the starting motor
to cool for one minute before restart. Failure to
operate according to this rule will damage the
starting motor.
CAUTION
If the engine fails to start after attempt for 3 times
or flames out after starting, inspect and ensure
that the generating set is placed in horizontal
surface and enough engine oil is injected.
If engine is equipped with an engine oil alarm, it
is possible to prevent engine start when the
engine oil in the crankcase is lower than the
minimum level.
During running-in, routinely inspect the engine
oil. See maintenance section for recommended
maintenance period.
After the engine starts successfully, and the
temperature has been increased, push the choke
lever to open the choke valve. If the engine runs
unstably (shaking exists), push the choke lever to
the HALF open position. Then push it to the FULL
open position after engine runs stably.