FONESTAR FO-20M44XT Manual De Instrucciones página 6

EN
MATRIX REMOTE CONTROL
It is possible to control the matrix via the RS-232 or the TCP/IP ports.
COMMUNICATION PROTOCOL RS-232
In order to configure the device via the RS-232 port, use the cable provided to connect the matrix to your
PC. It is recommended that the applications Hyperterminal, I/O Ninja or similar applications are used and
configured in the following way:
Select the corresponding COM port and establish the following values:
- Bits per second: 9600
- Data bits: 8
- Parity: none
- Parity bits: 1
This is the list of commands and their function. Bear in mind that the symbols "[" and "]" are used below to
make the commands easier to understand. They must not be used when writing the command.
COMMAND
/%Lock;
/%Unlock;
Demo.
[x]All.
Sends all the input signals 1-4 to all the corresponding output channels (Input 1 to
All#.
All$.
[x]#.
[x]$.
[x]@.
All@.
[x]V[y].
Send the AV and IR signals from the input [x] to one or several output channels [y]
[x]B[y].
[x]R[y].
Status[x].
Locks the buttons on the front panel of the matrix
Unlocks the buttons on the front panel of the matrix
Establishes the demo mode. Every 2 seconds (switching interval), the matrix
configuration switches automatically among:
(when it finishes it returns to Input 1 - Output 1 and continues in this way)
Sends the input signal [x] to all the output channels
Output 1, Input 2 to Output 2, Input 3 to Output 3 and Input 4 to Output 4)
Sends the input signal [x] to the output channel [x]
Send the AV signal from the input [x] to one or several output channels [y]
(if you wish to send the AV input signal to several output channels, separate the
different output channels with a comma)
(if you wish to send the AV and IR input signals to several output channels,
separate the different output channels with a comma)
Send the IR signal from the input [x] to an output channel [y]
Checks and informs on the output channel connection status [x]
FUNCTION
... Input 1 - Output 1
... Input 2 - Output 1
... Input 3 - Output 1
... Input 4 - Output 1
... Input 1 - Output 2
... Input 2 - Output 2 ...
... Input 4 - Output 4
Disconnects all the output channels
Disconnect the output channel [x]
Connect the output channel [x]
Connect all the output channels
- 6 -
...
...
...
...
...
...