Deactivating And Activating The Ionizer; Mounting And Removing The Ionizer Cover - VHF S5 Instrucciones De Uso Originales

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

S5 – Operation: Preparing jobs
6.6 Deactivating and activating the
ionizer
The ionizer considerably reduces the required cleaning
effort after dry machining. However, using the ionizer
also contributes to the overall compressed air
consumption of the machine.
You can decide whether you want to activate or deac-
tivate the ionizer via DENTALCNC. This is a general
setting that will affect all jobs that you machine.
To deactivate or activate the ionizer, do the fol-
lowing:
a. Start DENTALCNC.
a. Open the DENTALCNC Application settings with
the following icon in the main icon  bar: 
a. Open the General settings with the following
icon in the local icon  bar: 
b. Deactivate or activate the Ionizer activated option.
6.7 Mounting and removing the ion-
izer cover
The ionizer can only operate during dry machining. A
removable cover provides protection from moisture
during wet machining. You need to remove the ionizer
cover for dry machining and mount it for wet
machining.
Machine damage if you do not
NOTICE
mount or remove the ionizer
cover as required
If the ionizer cover is not mounted for wet machining,
the cooling liquid can cause a short circuit and damage
the machine. If the ionizer cover is not removed for dry
machining with ionizer, the pressurized air from the
ion jets can create an overpressure and damage the
machine.
Before you start wet machining, mount the ionizer
cover.
Before you start dry machining with ionizer, remove
the ionizer cover.
Before you start dry machining with ionizer, remove
the ionizer cover:
a. Open the working chamber door.
b. Switch off the machine at the main power
switch.
c. Pull down the ionizer cover (marked orange) at
the rear side, and remove it from the ionizer.
F
IG
F
IG
MARKED BLUE
Original Operating Instructions:  S5
Version: 12/15/2021
. 40 R
EMOVING THE IONIZER COVER
d. Place the cover in the storage area above the ion-
izer: position the recesses (marked blue) of the
cover on the pins (marked orange) of the stor-
age area.
. 41 P
LACING THE IONIZER COVER IN THE STORAGE AREA
,
)
PINS MARKED ORANGE
The ionizer cover is held in place by magnets.
Before you start wet machining, mount the ionizer
cover:
a. Open the working chamber door.
b. Switch off the machine at the main power
switch.
c. Remove the ionizer cover from the storage area,
by pulling the upper edge towards yourself.
d. Place the cover on the ionizer: position the
recesses (marked blue) of the cover on the pins
(marked orange) next to the ionizer.
EN 35
(
RECESSES
Tabla de contenido
loading

Tabla de contenido