Remote Control; Importante - Outsunny B31-390 Manual De Instrucciones

brown wire to brown
blue wire to blue

REMOTE CONTROL

IMPORTANTE

1. When the transmitter cannot control the receiver, please check whether the battery switch contact is normal, whether
the positive and negative poles are placed correctly, and whether the battery is sufficient. If the battery voltage is too
low, it will affect the transmitting intensity and cause remote control failure. Please replace the battery in time.
2. When the transmitter cannot control the receiver, please check if there are similar products nearby. The simultaneous
transmission of radio waves by the same kind remote control products will cause interference to each other and affect
the receiving effect.
3. The battery will decrease in power over time. Please replace the battery before it leaks to avoid damage to the
transmitter. Please handle the used battery properly. Keep the battery out of the reach of children.
4. If you do not use it for a long time, please remove the batteries from the transmitter.
8.

Connect brown wire from fan to brown wire from
LED light kit and then connect blue wire from fan to blue
wire from LED light kit.(SS)
 Secure the LED light kit in the light kit pan (D).
 Place the glass bowl (E) into the light kit pan (D) ,
aligning the three flat areas on the top flange of the glass
bowl (E) with the three raised dimples in the light kit pan
(D). Turn the glass bowl (E) clockwise until it stops.
1- Fan ON/OF
2- Fast speed
3- Middle speed
4- Low speed
5- 1 Hours delay
6- 2 Hours delay
7- 4 Hours delay
8- Light kit ON/OF
Using 1pcs of 12V-23A batteries.
7