Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Alert Symbols：
: The symbol refers to a hazard which can result in severe personal injury or death.
DANGER
: The symbol refers to a hazard or an unsafe practice which may result in severe personal injury
WARNING
or death.
: The symbol refers to a hazard or an unsafe practice which may result in minor personal injury,
CAUTION
product, or property damage.
: Refers to the remarks and instructions related to the operation, maintenance, and service.
NOTE
Installation, maintenance and repair of this unit must be performed by qualified, licensed service personnel.
Read these instructions thoroughly before installation or operation. Failure to follow these instructions may
result in improper installation, service or maintenance, possibly resulting in fire, electrical shock, property
damage, personal injury, or death.
Before installation, check if the voltage of the power supply at the installation site is the same as the voltage
shown on the nameplate.
DANGER
WARNING
Read this manual carefully before using the equipment. If you still have any difficulties
or problems, consult your dealer.
The equipment is designed to provide you with comfortable room conditions. Use
this unit only for its intended purpose as described in this installation and operation
manual.
Do not perform any alteration to this product, otherwise, it may cause water leakage,
equipment failure, short circuit, electric shock, fire, etc.
Piping, welding, and other such work should be carried out far away from any
flammable and explosive materials, including the air conditioner refrigerant, in order to
guarantee the security of the site.
To protect the equipment from heavy corrosion, avoid installing the outdoor unit in
the place, where sea water can splash directly onto it or in sulphurous air near a spa.
Do not install the air conditioner where excessively high heat-generating objects are
placed.
If the power cable is damaged, it must be replaced by a service professional.
The place where this product is installed must have the reliable electrical grounding
facilities and protections. Do not connect the grounding of this product to air ducts,
drain pipes, lightning protection facilities, as well as other piping lines to avoid electric
shock and damage caused by other factors.
Wiring must be done by a qualified electrician. All the wiring operations must be
conducted according to local electrical codes.
Consider the capacity of the electric current of your electrical meter and
socket before installation.
The power wire where this product is installed should have the independent leakage
protection device and the electric current over-load protection device provided for this
product.
Never use gasoline or other inflammable gas near the equipment to avoid danger.
When any abnormality like burnt smell, deformation, fire, smoke, etc. is found, you
should stop using the equipment, immediately disconnect the main power supply and
contact the dealer.
The first 6 inches of supply air plenum and duct work must be constructed of sheet
metal as required by NFPA 90B.
The supply air plenum or duct must have a solid sheet metal bottom piece directly
after the air handler unit with no opening, registers or flexible air ducts located in it. If
flexible supply air ducts are used, they may be located only in the side walls of the
rectangular plenum, a minimum of 6 inches from the solid bottom.
1
Caution Statements
Tabla de contenido
