Installation Steps
1.
Please install your network cards first before the AP
2.
Screw-in the antenna (clockwise) into the Antenna connector
3.
Connect the power and LAN cable to the back
4.
Use your wireless card to do a site survey, the default SSID is
airlive and Channel is 11
5.
If you need to change AP's configuration, please follow the
procedure below:
The AP's default IP address is 192.168.100.252. Please make
sure your computer IP is in the same subnet as the AP (i.e.
192.168.100.x)
Open the web browser and enter 192.168.100.253.
Installation Steps
Wireless: Basic Setting
This page includes all primary and major parameters. Any parameter
change will cause the device to reboot for the new settings to take effect.
Mode: This Wireless Access Point can support three modes AP, Client, and
Bridge.
The default is set to AP mode. Click the pull down arrow
change it to Client mode.
To change to Repeater mode, you will have to go to Wireless/WDS
setting to enable WDS.
Network Type: When in Client mode, you can select between Ad-Hoc and
Infrastructure.
Wireless Access Point
WL-5450AP / WL5460AP
All manuals and user guides at all-guides.com
you can
English
2
2