Best D49M30SB Manual De Instrucciones página 6

CUT COUNTERTOP OPENING
1. Lay out and cut the cooktop cut-out far enough FORWARD so
downdraft will fit behind it.
2. Set cooktop in place and slide it as far forward as possible
without exposing any gaps. Center and square it with edges
of countertop.
COOKTOP
Template against back
edge of cooktop.
3. Place the plastic template against the back flange of the cook-
top or back edge of slide-in range countertop opening. Center
the template. Trace around template to mark the downdraft
opening.
4. Remove cooktop from countertop.
5. Cut downdraft opening. Be careful not to chip edges of countertop.
INSTALL HOUSING INTO
CABINET
1. Remove cooktop.
2. Set housing into cabinet / countertop opening as far back as
possible and make sure it is level.
All manuals and user guides at all-guides.com
COUNTERTOP
OPENING FOR
SLIDE-IN RANGE
Template against back
edge of countertop opening.
Models D49M30SB • D49M36SB • D49M48SB
3. Extend SUPPORT LEGS and attach to bottom of cabinet with
(2) SCREWS through each leg. Tighten HEX SCREWS.
If cabinet bottom is removed:
Use blocks as spacers between floor and supports legs.
4. Extend UPPER SUPPORT BRACKETS and attached to sides
of cabinet with (2) SCREWS through each bracket.
Installations using FLEX BLOWER only:
5. Loosen (4) SCREWS attaching BLOWER SUPPORT LEGS
to FLEX BLOWER. Extend legs and secure them to bottom of
cabinet with a SCREW through each bracket.
.500 WOOD
SUPPORT
LEG
UPPER
SUPPORT
BRACKET
(2)
#10 X .500
WOOD
SCREWS
FLEX
BLOWER
(4) 1/4-20
X .500
SCREWS
SCREWS
Page 6
HEX
SCREW
(2) #10 X
SCREWS