Operation - Senix LSPG-L3 Manual Del Operador

Recoil Starter Hanlde
Recoil Starter Rope
Star Knob
Cutting Height Adjustment Lever
Side Discharge Cover
BLADE CONTROL
The blade control is attached to the upper handle of the mower. Depress and hold
against the upper handle to operate. Release it to stop the engine and blade.
WARNING
This blade control is a safety device. Never attempt to bypass its operation.
SIDE DISCHARGE COVER
The side discharge cover has been installed before delivery. Follow instructions in
the assembly section to use the side discharge cover.
WARNING
Keep hands and feet away from the chute area on cutting deck. Refer to warning
label on the unit.
WWW.SENIXTOOLS.COM
Lower Handle
Oil Tank Cap
Rear Wheel

OPERATION

Blade Control
Upper Handle
Cable Clamp
CUTTING HEIGHT ADJUSTMENT LEVER
There are four cutting height adjustment levers respectively located on four wheels.
5 cutting heights (from 1.25inch to 3.75inch) can be achieved by these four levers.
To adjust the cutting height, refer to the assembly section.
RECOIL STARTER
Pull the recoil starter rope to drive the recoil starter until the engine starts. Recoil
starter rope can be clamped into the rope guide on the right upper handle for
facilitating the pulling operation. Stand behind the unit, hold the blade control,
then pull the recoil starter rope can start the unit.
PRIMER
The primer is located on the left side of the engine. The primer is used to pump gas
into the carburetor and aid in starting the engine.
Fuel Tank Cap
Primer
Front Wheel
Mower Deck
11