Before Use; Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil Centec Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
All manuals and user guides at all-guides.com
Centec.book Seite 12 Mittwoch, 4. Mai 2011 5:00 17

3 Before use

3.1 Unpacking

3
Before use
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of no
longer needed packaging material properly.

3.2 Selecting the proper nozzle

1
2
A
B
3

3.3 Assembly

B
A
1
4
A
B
5
12
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
4
5
The crevice nozzle and the furniture brush are included as
3*
accessories in the scope of delivery besides the floor nozzle (Fig. 2/1).
- Crevice nozzle (Fig. 2/4): Use this to vacuum dust from hard to
reach places.
- Furniture brush (Fig. 2/5): Use this to vacuum dust off objects that
have sensitive surfaces.
*Optionally available (i.e. included in the scope of delivery depending
on model and features) are also:
- Parquet brush (Fig. 2/2*)
6*
Its long bristles make it especially suitable for cleaning delicate
surfaces (e.g. parquet and laminate floors).
- Turbo brush (Fig. 2/3*)
2*
This has a rotating brush head and is most suitable for thoroughly
deep cleaning of carpets. The brushing also raises the carpet pile.
- Long flexible crevice nozzle (Fig. 2/6*)
Use this to vacuum dust from distant, hard-to-reach places.
NOTE:
When you use the long, flexible crevice nozzle, under certain circum-
stances the pressure inside the vacuum cleaner might drop too far thus
triggering the safety valve. The signal for this is e.g. a whistling noise
(depending on the vacuum cleaner model) and greatly reduced suction
performance. In this case, depending on the vacuum cleaner model and
equipment, you have to reduce the suction power or open the bypass
vent until the valve no longer triggers.
2. Push the accessory bracket onto the telescopic tube as shown, or onto
the handle (Fig. 3/A).
3. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not
connected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
1
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
C
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the
release latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.
Tabla de contenido
loading

Tabla de contenido