GET RX1 PRO Guia De Instalacion página 3

5. The RPM limiter threshold of the RX1PRO maps is higher
than the standard ECU.
6. To use and manage the GPA technology, it is necessary to
install GET GPA Switch or GET LC-GPA module (both sold
separately), or manage it with GET Maya Software (sold
separately).
7. To change RX1 Pro injection map, it is necessary to use GET
Maya programming software (sold separately).
8. If the bike does not start or the engine is irregular, be sure
that the RX1 Pro ECU chosen is compatible with your bike
model and year, verify that the ECU is connected properly, and
always perform a TPS calibration.
9. OEM handlebar commands for map change and launch
control will not work after installing GET RX1 Pro ECU. Please
only use GET Map Switch (included in the kit) and GET LC-GPA
module (sold separately).
B. RX1 PRO SPECIFIC INSTALLATION
RX1 PRO is a fully programmable plug&play ECU. RX1 PRO is
the best solution both for original and modified engines: it is
possible to adjust the calibration map through both WiGET App,
by using the WiFi-COM device, and/or MAYA software.
WiGET App
RX1 Pro comes with 2 maps developed by GET R&D
Department, which can be easily switched thanks to the
Map Switch included in the kit.
3
EN