Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Remember that... Before proceeding with the installation, the extractor hood
must be disconnected from the electrical network, turn off the omnipolar
isolation switch or unplug it from the mains socket.
The hood must be placed just below the smoke outlet hole in the kitchen. To
obtain the best performance, the optimum height of the hood with respect to
the worktop must be between 65 and 75 cm.
1. Installation of the main body of the range hood
a) Using the installation template (supplied) and at the minimum
recommended height of 65 cm, mark holes A and C.
b) Drill four holes with a 8mm diameter drill bit at marks A and C, then
insert plugs 5 (8mm diameter).
c) Mark the holes B on the upper part next to the ceiling and make two
holes with a 6 mm diameter drill bit, then insert the plugs 8 (6 mm
diameter).
d) Fix the chimney support 4 using the screws 7 (3.9 x 30 mm).
e) Insert the fixing screws of the main body of the hood 6 (5 x 50 mm) into
the holes with plug A, and leave a few millimeters without tightening.
f)
Place the main body of the hood on the screws 6, and finish tightening
the screws 6.
8
Tabla de contenido
