FONESTAR FO-459-TX Manual De Instrucciones página 4

EN
2.2 Point-to point configuration.
3. Infrared usage guide
3.1 Infrared transfer
The extension cable of the infrared emitter must be connected to the infrared output port of the TX
(transmitter) of this extension matrix, and the extension cable of the infrared receiver must be
connected to the infrared input port of the RX (receiver) of this matrix extender. The emitter of the
infrared emitter should be placed as close as possible to the infrared receiver of the signal source
device.
3.2 Infrared remote control.
Using the infrared remote control to set / select the channel of this HDMI extender matrix.
4. Application control usage guide
4.1 HDbitT Matrix Controller MODE-"Matrix Controller" APP."
4.1.1 Android User: download the "Matrix Controller" application on your mobile phone from the
website: http://www.hdbitt.com/down load-matrix/.
IOS User: please download the "Matrix Controller" app from the app store.
4.1.2 First, connect the video matrix controller to the IGMP switch.
Then connect the mobile phone / tablet and the video matrix controller via the "MATRIX"
access point to each other (as figure 1, the wifi password is 12345678). At this time, open the
downloaded APP matrix control, you will enter the interface as shown in figure 2, and APP
control will start.
Figure 1
- 4 -
Figure 2