Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
REMOTE CONTROL
1.-
: start/pause playback.
2.-
EQ: allows you to select between the different existing equalisations.
3.-
CH -/CH +: one press on these buttons allows you to go to the previous/next folder.
4.-
VOL -/VOL +: player volume controls.
5.-
/ : one press on these buttons skips to the previous/next audio track.
6.-
0-9: numeric buttons for automatic selection of the desired audio track.
7.-
MODE: allows you to select the desired audio source.
8.-
ENTER: allows you to change the play and repeat mode of the player (repeat all, repeat folder, repeat
1 and random play).
CONNECTION AND OPERATION
Before making any connections, make sure that all equipment is turned off and disconnected from the
power outlet.
The basic connections are as follows:
1.- Microphone input (MIC INPUT): Connect a microphone to this input. The input is balanced, for dynamic
microphones with an XLR connector.
2.- Line input (AUX INPUT): connect an external sound source (CD player) to the input, audio player, etc).
Line input is with 2 x RCA connectors.
3.- Turn on the amplifier with the switch located at the bottom of the rear panel. The device can be powered
directly by the current or by using the internal battery.
Once the connections have been made according to your needs, connect the other devices to the mains
socket and switch them on. After use, do not forget to turn off and disconnect the device from the power
outlet.
INSTRUCTIONS FOR USE
RECHARGEABLE BATTERY
To charge the battery, connect the equipment to a 230 V AC outlet using the power cable and turn it on with
the switch at the bottom of the rear panel. Keep the device connected to the mains socket and switched on
during the charging time, approximately 5 hours.
The battery life depends on the use and mode of operation of the equipment. In general, the battery life is
longer than 5 hours.
1
2
6
- 4 -
3
4
5
7
8
Tabla de contenido
