Pulsar APS-V Manual De Instrucciones página 6

Two batteries can be charged at the same time. Slot
y
EN
is for APS 5 batteries. Slot
2 batteries.
LED indication in battery charging mode
Battery level is from 0% to 25%
¬ ­ ­ ­
Battery level is from 26% to 50%
l¬
Battery level is from 51% to 80%
ll¬
Battery level is from 81% to 99%
lll¬
The battery is fully charged. It can be
llll
disconnected from the charger.
Defective battery. It is forbidden to use the
l­
battery.
LED indication in standby**
Battery level is from 0% to 25%
¬
Battery level is from 26% to 50%
l
Battery level is from 51% to 80%
ll
Battery level is from 81% to 99%
lll­
The battery is fully charged. It can be
llll
disconnected from the charger.
Defective battery. It is forbidden to use the
l
battery.
* Purchased separately or supplied as package contents
of a device.
6
** Standby mode – an operating mode in which batteries
is for APS 3 and APS are inserted into the charger, but the power adapter is not
connected. In this mode, the indication is on for 10 seconds.
Attention! When charging an APS 5 battery with a power
adapter that does not support USB fast charging technology,
the charge time increases and it is indicated by a slow flashing
LED light.
Attention! The charger heats up during fast charging. Excess
heat is removed through the radiator and does not affect the
device operation.
PRECAUTIONS
y
y
y
y
y
Always use this charger or APS 5 charger (for APS 5) or APS
charger (for APS 3 and APS 2) supplied with the device to
charge APS 5/3/2 batteries. Using the unsuitable charger can
cause irreparable damage to the battery and fire.
Do not charge the battery immediately after brining it from
cold to warm. Wait at least 30 minutes for the battery to
warm up.
Do not leave the battery unattended while charging.
Do not use the charger if it has been modified or damaged.
Do not leave the battery in a charger connected to the
network after charging is complete.
USER MANUAL