Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
INSTALLATION OF THE MAJOR COMPONENTS:
CONTROL MODULE: (P/N 1365269)
Select a mounting location inside the passenger compartment (up behind the dashboard). The
mounting location selected must be within 24" of the ignition switch wiring harness to allow con-
nection of the 6 pin main wiring harness.
Be certain that the chosen location will not interfere with proper operation of the vehicle. Avoid
mounting the module to or routing the wiring around the steering shaft/column, as the module or
wiring may wrap around or block the steering wheel preventing proper control of the vehicle.
Secure the module in the chosen location using cable ties or screws as necessary.
Do Not Mount The Module In The Engine Compartment, as it is not waterproof.
THE RECEIVER/ANTENNA VALET SWITCH LED ASSEMBLY: (P/N 1181245)
The Super-regenerative Receiver Antenna Assembly which includes the LED and Valet/Pro-
gramming switch provided with this unit allows routing from below the dash board for maximum
operating range. Choose a location above the belt line (dashboard) of the vehicle for best
reception. Special considerations must be made for windshield glass as some newer vehicles
utilize a metallic shielded window glass that will inhibit or restrict RF reception. In these ve-
hicles, route the antenna toward a rear window location for best reception. Secure the antenna
with double stick tape provided. After securing the antenna with tape, we advise also securing a
section of the antenna cable, (P/N 4120192) to a fixed support. This will prevent the antenna
from dropping down in case the double stick tape is exposed to extreme heat which may loosen
it's gummed surface. Route the connector toward the control module using caution not to pinch
the cable as this will cause poor or no RF reception to the control module. Connect the 3 pin RF,
2 Pin 1 wire LED, and 2 Pin 1 wire valet/programming connectors to their mating connectors on
the control module.
SIREN: (P/N 1365270)
Select a location in the engine compartment that is not accessible from below the vehicle. The
selected location must be clear of hot or moving parts within the engine compartment The siren
must be pointed downward to prevent water retention and the flared end must be pointed away
from and out of the engine compartment for maximum sound distribution. Before securing the
siren, check behind your chosen location to assure that the mounting screws will not penetrate
any factory wiring or fluid lines. Secure the siren mounting bracket using #8 self tapping screws
or by first using the mounting bracket as a template, scribe or mark the mounting holes. Drill the
marked holes using a 1/8" drill bit, then mount the siren using #8 sheet metal screws.
HOOD PIN SWITCH: (P/N 1363699)
The pin switch included in this package are intended for protecting the hood area of the vehicle.
In all cases, the switch must be mounted to a grounded metal surface. When the pin switch is
activated, (hood/trunk open), it will supply a ground to the input wire activating the alarm. In
addition, the hood switch is required for the safety shut down of the remote start unit. If the
vehicle is being worked on, this hood switch prevents the remote start activation even if the RF
command to start is issued. WARNING: This switch must be installed in all applications. Fail-
ure to do so may result in personal injury or property damage.
2
128-9104
2 of 32
