Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11.
Taking the striker from the pool latch kit, remove
the four small screws holding the cover in place
and then remove the cover. Next unscrew
adjustment screw holding mounting bracket and
remove mounting bracket (Fig. 14).
12.
Install round post mounting bracket A and turn
the adjustment screw clockwise until bracket is
engaged as illustrated (Fig. 15). Next replace the
cover to previous position and replace the four
small screws.
13.
Determine gate upright size. If 1
gate bracket (A) (Fig. 16). If 1
(B) with gate bracket (A) (Fig. 17).
14.
Position striker assembly on the gate upright
and align the vertical alignment marks. Then
using a pencil make a small mark on the gate
upright just above and to the side of the striker
assembly (Fig. 18).
15.
Release the striker assembly from the latch
assembly by lifting up on the latch release cap
(Fig. 19).
⁄
", only use
5
8
⁄
" use adapter
3
8
Remove
Cover First
Remove and Discard
Mounting Bracket
A
A
A
B
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
5
Tabla de contenido
