Installation The Led Light Module And Glass Shade - Hinkley 54 VELO Manual De Instrucciones

INSTALLATION THE LED LIGHT MODULE AND GLASS SHADE

Wire connectors
LED Light
module
Glass shade
Fig. 1
10 | hinkley.com
NOTE:
turning off the circuit breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not sufficient to prevent
electric shock.
Remove 1 of the 3 screws from the light mounting plate and
1
loosen the other 2 screws. (Do not remove)
Raise and hold the 16W LED light module close to the light
2
mounting plate and connect the 2-pin wire connections:
- White to white
- Black to black
Place the key holes of the 16W LED light module over the 2
3
screws previously loosened from the light mounting plate,
turn light module until it locks in place at the narrow section
of the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
Light mounting plate
NOTE:
turning off the circuit breaker or removing the fuse at fuse box.
Turning the power off using the fan switch is not sufficient to
prevent electric shock.
Raise glass shade up against the LED light kit and secure it to
4
Screw
fan by turning the glass clockwise until snug. DO NOT
OVERTIGHTEN.
5
Restore power and your light module is ready for operation.
Before starting installation, disconnect the power by
Before starting installation, disconnect the power by