Before Installation - Jocel JEXC-014566 Manual De Instrucciones

cardboard, box etc. for a proper cooling (Picture 3).

BEFORE INSTALLATION

Place the product at least one (1) meter away from heat resources (stove, radiator,
electric heater etc.). (Picture 4)
Do not place it opposite to the air conditioner chutes, under fans and direct door and
window openings. (Picture 5)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your
product's glass. That means an increase in the energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the
compressor section of your product. While approaching your product to the wall, be
careful that there is a gap of 150 mm (15 cm) between the wall and back of your device.
WARNING!
In very humid environments, ensure that floor and wall of the place where your product
is located, is not affected by water; against discharge water overflow danger.
In installations performed by an authorized person, they can inform the consumer on
the suitable place for installation and make suggestion, but the consumer shall give the
final decision on where the installation will be made. This above-mentioned process
shall also be stated on the relevant installation form by Authorized Service. In case of
any loss arising from the place of installation of the product according to the final
decision given by the consumer, all responsibility related to such loss shall belong to
the consumer.
Your product gives the best cooling performance according to the climate condition
under the conditions given below.
Therefore, be careful that the temperature of the environment where your product will
operate is at these levels.
Positioning
49