LUND 67420 Manual Original página 12

GB
It is forbidden to drill any holes in the product, as well as making any other modifi cations of
the appliance not described in the manual.
Move the appliance only when cooled, grasping the housing. Do not move the appliance by
pulling on the power cord.
The temperature at the place of installation and use of the appliance must be within the range
of +10 C ÷ +38 C, and the relative humidity must be below 90% without condensation.
O O
Recommendations for connecting the appliance to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the power supply corresponds to the values shown on the appliance's
rating plate. The plug must fi t into the outlet. It is forbidden to modify the plug in any way.
The appliance must be connected directly to a single power supply socket. It is forbidden to
use extension cords, adapters or double sockets. The power supply circuit must be fi tted with
a protective conductor and at least a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended and the position of the power cord must be set
so that it does not become an obstacle during operation. The power cord shall not be placed
a manner that would pose a risk of tripping. The power supply socket should be located in a
place where it is always possible to quickly remove the appliance power cord plug. Always
pull the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug are damaged, immediately disconnect it from the power supply
and contact an authorised service centre of the manufacturer for replacement. Do not use
the appliance with a damaged power cord or plug. The power cord or plug cannot be re-
paired and must be replaced with a new one that is free of defects if these components are
damaged. Replacement of the power cord and plug must be carried out by an authorised
service centre of the manufacturer.
Instructions for the use of the appliance
WARNING! The cooktop surface can be hot after use. Do not touch it, as it may cause
severe burns. Allow the cooktop to cool down.
When preparing dishes which may spread hot food fragments, personal protective
equipment should be worn to protect from burns.
Make sure that the fl oor near the appliance is not slippery. This will prevent slipping, which
can cause serious injuries.
Observe the food at all times and prevent it from burning during its preparation. Food left
unattended can burn, which can cause fi re and serious burns.
When preparing dishes, touch the cooktop surface only with utensils made of wood or plas-
tic. The utensils should be able to withstand the temperature generated by the cooktop. It is
forbidden to remove and distribute food using hands.
If any food is left on the cooktop during or after preparation, remove the food remains before
preparing another dish. Food remains can be burned, causing smoke, unpleasant smell, and
aff ect the taste of the prepared food. They may also be the cause of fi re. Use utensils made
of wood or plastic able withstand the temperature generated by the cooktop. Do not use
O R I G I N A L I N S T R U C T I O N S
12