Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Guide
STEP 7: Battery Dismantling and Installation
1.If the bike is provided with a battery, pull the insulation strip out of the gap of the battery cover
before using this product.
2.When battery replacement is required, remove the two cruciform slot screws on the electronic
control plate, and pull out the plate from the back (do not pull hard for the power cord on the back
are connected to the cycle body), remove the used battery, load the new battery into the battery
holder with the positive pole facing upwards ( "+" mark facing upwards), close the cover, and tighten
the screws.
The positive pole of the
battery faces upwards
Tabla de contenido
