Preparing For Use - hillvert HT-FORBES-15 Manual De Instrucciones

L - (not visible in the photo/at the rear of the engine between the muffler and
the air filter) Spark plug
3.2.
Assembling the appliance
a) Install the 8 hole rubber cover on the underside of the machine (at the
centreline of the machine wheels) using bolts.
b) Install the brake and wheels on the wheel axle, using the nut and
washer.
c) Attach the lower part of the holder to the base with four screws.
d) Attach the upper part to the lower part of the handle with the long pin
and clamping lever. Adjust the position of the top part of the handle
and tighten the clamping lever.
Refuelling
a) Make sure the machine is turned off and that the engine has been
cooling down for at least 2 minutes before you start refuelling. Refuel
only outdoors.
b) Unscrew the fuel tank cap [F]
c) Fill the fuel tank up to a maximum of 15mm below the top of the tank.
Don't overfill!
d) Close the fuel tank cap [F].
Topping up engine oil
a) Make sure that the machine is standing on a level surface.
b) Check the oil level using the dipstick [J].
c) If the oil dipstick shows low oil level, top up using 10w-30/10w-40/15w-
30/15w-40 non-synthetic engine oil.
d) Fill in the oil through the same hole as the dipstick [J].
e) When topping up the oil, check the oil level so that it falls between L
(low level) and H (high level). Don't overfill!
Please note: Before using the machine, top the oil up to the correct
level. The engine is delivered without oil. Operating the engine without oil
or with a low oil level will damage the engine.

Preparing for use