Makita DTW300 Manual De Instrucciones página 8

Reversing switch action
► Fig.6: 1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
Changing the application mode
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of the impact force changes every time you press the button
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton or .
► Fig.7
Application mode
(Impact force grade displayed on panel)
4 (Max)
3 (Hard)
2 (Medium)
1 (Soft)
: The lamp is on.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
.
Maximum blows
-1
4,000 min (/min)
-1
3,400 min (/min)
-1
2,600 min (/min)
-1
1,800 min (/min)
8 ENGLISH
Purpose
Tightening with the maximum force and
speed.
Tightening when the force and the speed
are desired.
Tightening with less force and speed than
Max mode (easier to control than Max
mode).
Tightening when the force and the speed
are desired.
Tightening when a good finishing is
needed.
Tightening when you need good control
power.
Tightening with less force to avoid screw
thread breakage.
Tightening when you need fine adjustment
with small diameter bolts.