Makita 9564PC Manual De Instrucciones página 8

1
008376
Pull the lever in the direction of the arrow after loosening
the screw. Mount the wheel guard with the protrusion on
the wheel guard band aligned with the notch on the
bearing box. Then rotate the wheel guard around 180°.
Fasten it with the screw after pulling lever in the direction
of the arrow for the working purpose. The setting angle
of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1
2
3
008377
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.To remove the wheel,
follow the installation procedure in reverse.
1
2
008378
To remove the wheel, follow the installation procedure in
reverse.
All manuals and user guides at all-guides.com
Installing or removing flex wheel
1. Screw
(optional accessory)
015766
Follow instructions for depressed center grinding
wheel/Multi-disc but also use back up pad over wheel.
See order of assembly on accessories page in this
manual.
Installing or removing abrasive disc
(optional accessory)
1. Lock nut
2. Depressed
center grinding
wheel/Multi-disc
3. Inner flange
008383
NOTE:
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
1. Lock nut wrench
2. Shaft lock
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
OPERATION
8
1
2
3
4
WARNING:
Always use supplied guard when flex wheel is on
•
tool. Wheel can scatter during use and guard helps
to reduce chances of personal injury.
Use sander accessories specified in this manual.
•
These must be purchased separately.
WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
NEVER bang or hit grinding disc or wheel onto
•
work.
1. Lock nut
2. Flex wheel
3. Back up pad
4. Inner flange
1. Lock nut
2. Abrasive disc
1
3. Rubber pad
2
3