Before Start-Up - Bühler technologies GAS 222.11 Guía Rápida

GAS 222.11
DANGER
When used in explosive areas:
Application limitations
Heated pressure vessels suitable for use in Ex areas bear an
ignition protection mark in the type plate. These pressure
vessels are only suitable for use in Zone 2 (equipment cat-
egory 3G).
5 Operation and Control
NOTICE
The device must not be operated beyond its specifications.
WARNING
Housing or component damage
Never exceed the maximum working pressure and temperat-
ure range of the drive.

5.1 Before Start-Up

Before starting the device, verify
• the hose- and electrical connections are not damaged and
correct installed.
• no parts of the gas probe have been removed.
• the safety and monitoring devices are installed and func-
tional.
• the gas inlet and outlet of the gas probe are open.
• ambient parameters are met.
• the performance specifications in the type plate are met.
• voltage and frequency in the type plate match the mains
values.
• all connection cables are installed without strain.
• precautions have been taken.
• cable glands are sealed properly.
• the earth is proper and functional.
When used in Ex areas, also verify the probe and all add-
on parts are suitable for use (observe type plates and ig-
nition protection markings) and compliance with ap-
plicable Ex regulations.
6 Maintenance
Always observe the applicable safety- and operating regula-
tions when performing any type of maintenance. Please refer
to the original operator's manual on the included CD or online
at www.buehler-technologies.com for maintenance informa-
tion.
7 Service and Repair
Please refer to the original operator's manual on the included
CD or online at www.buehler-technologies.com for a detailed
description of the unit including information on
troubleshooting and repair.
12 Bühler Technologies GmbH BX460037 ◦ 09/2021