Declaration Of Conformity; Special Safety Instructions; Specified Conditions Of Use; General Safety Information - FISCHER FIS DB S Pro Manual De Instrucciones

1. Declaration of Conformity

We declare under our own responsibility: These
battery-powered dispensers FIS DB S Pro and
FIS DB SL Pro, identified by type and serial
number *1), comply with all relevant regulations
of the directives *2) and standards *3). Techni-
EN
cal documentation at *4) – see page 4.

2. Specified Conditions of Use

The unit is designed to squeeze out injection
mortar as well as sealant or adhesive from
cartridges.
It is not designed for foodstuffs or for medical/
veterinary purposes. It should not be used with
pressurized cartridges. The gun should also
not be used as a lifting/spreading tool.
The user bears sole responsibility for any
damage caused by inappropriate use.
Generally accepted accident prevention reg-
ulations and the enclosed safety information
must be observed.

3. General Safety Information

For your own protection and for the pro-
tection of your power tool, pay attention
to all parts of the text that are marked with
this symbol!
Warning: Reading the operating instruc-
tions will reduce the risk of injury.
Warning: Read all safety warnings and
instructions. Failure to follow all safety
warnings and instructions may result in
electric shock, fire and/or serious injury.
Keep all safety instructions and information
for future reference.
Pass on your power tool only together with
these documents.
10

4. Special Safety Instructions

A slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes,
wash them with clean water and seek
medical attention immediately!
Protect battery packs from water and
moisture!
Do not use faulty or deformed battery packs!
Do not expose battery packs to fire!
Do not open battery packs!
If the machine is defective, remove the battery
pack from the machine.
Do not touch or short circuit battery pack
contacts!
Remove the battery pack from the machine
before making any adjustments, changing
tools, maintaining or cleaning.
Make sure that the tool is switched off before
fitting the battery pack.
Do not use frozen or set injection mortars,
adhesives or sealants.
Do not overload the motor! If the motor is
overloaded, switch off the device and remove
the battery pack. Determine the cause of the
problem and resolve it.
Always wear eye protection.
Danger of crushing! Do not take hold of the
toothed rod! Ensure that nothing is caught by
the toothed rod!
Follow national requirements for the materials
you want to work with.
Observe the instructions for the processed
material.