Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Tool usage
NOTE: Remember that despite being really similar to
an abrasive chop saw, this tool requires less force and
pressure to be operated.
Make sure the workpiece is fixed and tightened according
to the users guide. The workpiece must be completely
fixed and straight before making any cut. Make sure the
workpiece has the proper support to avoid accidents.
Check the lower guards to make sure they work as
intended. Press the trigger and allow the motor to reach
its maximum speed. Press the carter lever with your thum
and slowly lower the tool head until the disc touches the
workpiece and starts cutting. remember to stay sideways
towards the saw. Always be careful. As you cut do not make
excessive force, there is no need to force the cut. Allow
the saw to complete the cut at its own speed according
to the material to be cut. Increase pressure over thicker
materials. Do not apply pressure over thin materials.
Warning: If the saw blade gets stuck while cutting
release immediately the trigger to swithc the tool off.
After completing the cut, rise the cutting head until the disc
is no longer in contact with anything before releasing the
trigger. Make sure the tool has completely stopped before
removing the workpiece or making any further actions.
Maintenance
use compressed air to blow the tool holes periodically.
Clean every plastic component with a damp cloth. NEVER
use chemicals to clean the plastic pieces, they may get
damaged. Use protection glasses while using compressed
air. We recommend taking the tool to a technical support
once a year for a full clean & check.
Maintenance and service
Before any work on the machine itself, pull the
mains plug.
Clean the ventilation slots of your power tool
regularly with a soft brush.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.
Repair service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information on
spare parts can also be found under:
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
ENGLISH
16
Warranty
Warranty card
Included in the documentation that accompanies this
equipment, you should find the warranty card. You should
fill out the card completely and return to vendor with a
copy of purchasing receipt or invoice and you should
receive a receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
Disposal and recycling
The machine, accessories and packaging should be sor-
ted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2012/19/EC for
Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally correct
manner.
Subject to change without notice.
6. Regulations
6.1 Technical features
= Power
= No load speed
= Disc size
Ø
x
= Cutting width
= Cutting depth
y
= Mass
L
= Sound power level
WA
L
= Sound pressure level
PA
= Vibration
The values given are valid for nominal voltages [U]
230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower
voltage and models for specific countries, these values
can vary. Please observe the article number on the type
plate of your machine. The trade names of the individual
machines may vary.
16
Tabla de contenido
