Safety Advice - Steamery Pilo No.1 Fabric Shaver Manual

How to Use Pilo No.1 Fabric Shaver
• Use the usb cable to charge the Pilo No.1 fabric shaver. The button light will turn red to
indicate that it is charging.
• When the battery is fully charged the button light will turn green. Unplug the device when
the charging is completed. It normally takes 5 hours to recharge the battery.
• Turn on the machine by pressing the on/off button.
• To use it, gently swipe the fabric with the trimmer to remove fuzz and pilling. If you push the
Pilo No.1 Fabric Shaver hard against the fabric, you risk damaging it. Therefore, remember
to always try the Pilo No.1 Fabric Shaver on a small, less notable spot before going over the
whole piece. Please note that Steamery does not take responsibility for this kind of damage.
• Please note: to eliminate the risk of damaging the fabric, always place the garment on a flat
surface before you start using the Pilo No.1.
• When the on/off button starts to flash in red, the device needs charging.
• Turn off the machine by pressing the on/off button.
• It is important to remove the fuzz from the machine. To do so, turn off the machine and
then remove both the storage bin and the blade protector, then use the little brush for easy
cleaning. Remember to remove the fuzz around the razor blades as well. Pay extra attention
that no hairs or threads are around the spinning asix.
• In case the machine is subjected to excessive pressure or if the motor gets blocked, the
machine will automatically shut off, in order to protect the motor from overheating and
breaking. You will be able to turn the machine back on after 2 seconds, when its components
have cooled down.

Safety Advice

1. Always unplug the device from the power outlet after charging and before you clean it.
2. Do not use the Pilo No.1 fabric shaver on the garment you are wearing.
3