Inateck BCST-71 Manual Del Usuario página 8

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 106
3. Enable the Bluetooth of the device to be connected, e.g. PC, cellphone or tablet. You can
EN
do that like below.
Windows XP: Click Control Panel->Printers and Other Hardware->Add Bluetooth Device
Windows 7/8/8.1: Click Control Panel->Add Devices
Windows 10: Click Setting->Devices->Bluetooth
macOS: Click System Preference->Bluetooth
iOS: Click Setting->Bluetooth
android: Clik Setting->Bluetooth
Enable the Bluetooth on host device and it will automatically search for BCST-71. After
a few seconds 'BCST-71******' will appear in the list of available devices. Pair the two
devices. A chords sound means successful pairing.
4. Open a file on computer and move cursor to the blank where scanning output should
be placed. Scanning results can be displayed on computer then.
Note:
1) Normally BCST-71 can re-connect to previously connected device automatically. If it fails,
please remove the paring history of BCST-71 in the list of host device. Afterwards, pair
them again.
2) HID and GATT are two modes of Bluetooth. The pairing method mentioned above refers
to HID, which is the most commonly used mode. If you want to use BCST-71 under GATT
mode, please contact our customer service.
Wired Mode:
1. Connect Inateck BCST-71 with computer via USB cable
2. Power on Inateck BCST-71 by toggling switch from OFF to ON and short press the
trigger. Inateck BCST-71 will continuously beep. Beep stops after successful connection.
3. Open a file on computer and move cursor to the blank where scanning output should
be placed. Scanning results can be displayed on computer then.
6
Tabla de contenido
loading

Tabla de contenido