Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL GE-CH 36/61 Li Manual De Instrucciones Original

•
Cut the sides of the hedge with curve-shaped
movements from the bottom up (see Figure
13).
What to do if the blade gets blocked
1. Stop the equipment.
2. Remove the battery.
3. Remove the jammed material from the blade
(wear work gloves to prevent injury when you
do so).
After using
1. Switch off the equipment.
2. Remove the battery.
3. Allow the equipment to cool down and then
store it out of children's reach.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Before putting the hedge trimmer away and
cleaning it, switch it off and remove the battery
pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Use a brush to remove deposits from the
safety guard.
7.2 Maintenance
•
The cutters should be cleaned and lubricated
at regular intervals in order to ensure best
performance at all times. Remove deposits
with a brush and apply a thin film of oil (Fig.
14).
•
There are no other parts inside the equipment
that require maintenance.
Anl_GE_CH_36_61_Li_SPK13.indb 18 Anl_GE_CH_36_61_Li_SPK13.indb 18
GB
•
Double blades are not allowed to be used
if they are damaged or worn and must be
replaced by original spare parts from the ma-
nufacturer.
•
Arrange for an expert or our service workshop
to carry out all safety-related maintenance
work and the replacement of defective parts
or the sharpening or replacement of the dou-
ble blade, so that you can be sure that the
hedge trimmer is safe to use.
7.3 Storage
•
When not in use the hedge trimmer can be
hung on a nail, screw or the like for storage,
with the cutter rail guard fitted (Fig. 15/Item.
A).

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Faults
Check that the battery is charged and the char-
ging unit is working. If the equipment will not work
despite the voltage supply being present, please
send it to the customer service address below.
- 18 -
19.10.2021 14:55:14 19.10.2021 14:55:14