Equipment Assembly; Operation And Use - Tramontina CC45M Manual De Uso Y Mantenimiento

Baffle assembly
To assemble the baffle, position it on the chassis as shown in the figure, [Fig. 01, page 03], fit the two M6 (1)
screws into the baffle holes, using the flat washers (2) between the screw head and the baffle, [Fig. 02, page 03].
To complete the assembly and fasten the assembly using the nuts M6 (3) that accompany the product, [Fig. 02,
page 03].
Assembly of the lower arm
To fasten the lower arm, use 4 screws and 4 M10 nuts that are provided with the product.
At first, position the arm (1), so that the flat surfaces remain inside the arm bracket, [Fig. 03, page 03].
Complete the assembly inserting the screws (1), fastening them with the nuts (2), [Fig. 04, page 03].
Assembly of the upper arm
Insert the screws making sure they go through the two arms.
Tighten the set with the handle (1), [Fig. 05, page 03].
Once the arms are installed, release the engine brake actuating the braking lever; pull the engine driving cord and
couple it to the arm hook, [Fig. 06, page 03].
Adjusting the upper handle height
To adjust the height of the lawn mower handle, remove the screw (1) and the washer (2) that attach the lower
handle [Fig. 07, page 04]. Now choose one of the 3 height adjustments "A" [Fig. 08, page 04], "B" [Fig. 09, page
04], or "C" [Fig. 10, page 04]. After that, insert the screw (1) and the washer (2) in the chosen position and firmly
tighten them.
1 - Cover of the fuel tank.
2 - Measuring rod for the oil level.
2
Filling
Oil
This engine is supplied without lubricant oil. Fill with 5W30 Synthetic oil. Quantity: 600 ml.
The first oil change should happen after 5 hours of use. Subsequent oil changes should be done every 25 hours
of operation or every 6 months (whichever happens first).

EQUIPMENT ASSEMBLY

OPERATION AND USE

1
4
3
Engine 4 hp
Powermore
2
Engine 6 hp
Powermore
12
3 - Air filter.
4 - Fuel injection button (primer).
1
3
EN