Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DMX-512 connection / connection between fixtures
The wires must not come into contact with each other, otherwise
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of
the controller directly with the DMX-input of the first fixture in the DMX-chain. If you
wish to connect DMX-controllers with other XLR-outputs, you need to use
adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the
next fixture. Always connect one output with the input of the next fixture until all
fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator.
Solder a 120 resistor between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it
in the DMX-output of the last fixture.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
OPERATION
1. DMX operation mode
Addressing
After you connect the item to the mains, the item starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards. Turn the objective-lens
for adjusting the focus in order to obtain a sharp projection. The four-digital LED
display on the back side of the item allows you to assign the DMX fixture address,
which is defined as the first channel from which the item will respond to the controller.
If you set, for example, the address to channel 7, the item will use the channel 7 to 15 for
control. Please be sure that you don't have any overlapping channels in order to control
each item in correctly and independently from any other fixture on the DMX data link. If
two, three or more items are addressed similarly, they will work similarly. When the item
finishes resetting,
address by pressing the UP or DOWN buttons.
DMX Controlling:
After having addressed all items, you may now start operating these via your lighting
controller. After switching on, the item will automatically detect whether DMX 512 data
is received or not. If the data is received, the red led dot will pass flashes on the
display .
Channel
DMX-value
1
PAN
0--------255
2
TILT
0-------255
3
COLOR
0--------14
15-------29
30-------44
MINISCAN LED 60
will flash in the led display and then set the desired DMX
Feature
pan movement 175 degrees/head rotation 0-180 degrees
tilt movement 80 degrees/head rotation 0 - 85 degrees
white
Red
yellow
Rev. 150501
- 2 -
User Manual/Manual de Uso
EN
Tabla de contenido
