Safety Instructions - Mark MINISCAN LED 60 Manual De Uso

EN
USER MANUAL
MINISCAN LED 60
INTRODUCTION
Thank you for having chosen the item. You will see you have acquired a powerful
and versatile device. Unpack your item. Before you initial start-up, please make sure
that there is no damage caused by transportation. Should there be any damaged,
consult your dealer and do not use the device.

SAFETY INSTRUCTIONS

Be careful with your operations. With a dangerous voltage you can suffer a dangerous
electric shock when touching the wires!
Keep this device away from rain and moisture!
Unplug mains lead before opening the housing!
For your own safety, please read this user manual carefully before initial start-up.
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room
temperature. Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution! Make sure that
the available voltage is not higher than stated on the rear panel. During the operation,
the housing becomes very hot. Do not switch the device on and off in short intervals as
this would reduce the lamp's life. Never look directly into the light source, as sensitive
persons may suffer an epileptic shock (especially meant for epileptics)!
Keep away from children and amateurs! . This product is designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres
etc. The minimum distance between light-output and the illuminated surface must be
more than 0.5 meters. Always fix the fixture with an appropriate safety-rope. The
maximum ambient temperature t = 45° C must never be exceeded. Operate the device
a
only after having become familiar with its functions.
Features
MANUAL FOCUS, WIDE BEAM SPREAD COVERS A LARGE AREA, EASY-TO-USE - OPERATIONAL BY ITS OWN
BUILT-IN LIGHT SHOW (SOUND ACTIVE) OR DMX-512 (USIT T),HIGH OUTPUT,VERY LOW POWER
CONSUMPTION- CONNECT MORE UNITS IN A SINGLE CIRCUIT ,EXTREME LONG LIFETIME OF THE LEDS
(100,000 HR. RATING),LINKABLE VIA 3-PIN XLR DMX IN/ OUTPUT,9 DMX CHANNELS,LED DMX DISPLAY
WITH 4-BUTTON MENU, RICH, SATURATED COLORS THAT WILL NOT FADE, RUNS EXTREMELY COOL! -
NO DUTY CYCLES! - RUN ALL NIGHT!LASER SIMULATED AERIAL EFFECTS
Installation
On the rear panel of the item you can find an XLR-j ack (DMX Out) and an XLR-plug (DMX
In), which can be used for connecting several devices. Choose the device which is to
control the effects. Connect the DMX OUT-jack with the DMX IN-plug of the next device.
MINISCAN LED 60 - 1 -
User Manual/Manual de Uso