Kathrein UFO DVB-S2-QAM Manual De Instrucciones página 18

1.7 Switching the output on/off
The output channel unit is selected using the "<" and ">" buttons.
O1 1236 MHz
27.500 MS/s
Outp. * S21
6.900 MS/s
Main menu (output 1 switched off)
The output can be switched on and off using the output channel sub-menu.
The following settings are possible: on or off
Pressing the "Sub-menu" button
The output is selected using the "<" and ">" buttons and adjusted using the "+" and "-" buttons.
When the output is switched off an indicator (*) is shown in the main menu, on the left beside the output channel.
If any channel unit (O1 to O8) is not used, then its output signal must be switched off.
1.8 Selecting the output symbol rate
The output symbol rate is selected using the "<" and ">" buttons.
O1 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
The output symbol rate can be adjusted continuously from 1.5 MS/s to 7.15 MS/s in 0.001 MS/s steps using the "+" and "-" buttons.
The digits can also be entered individually to a resolution of 0.001 MS/s:
• Press the "Change setting mode" button
• The fi rst digit fl ashes and can be input directly using the buttons on the keyboard
• After the fi rst digit has been input, the second fl ashes, and so on
• To make a correction, press the "Back" button to skip one place to the left
• After the last digit has been set, press the "Change setting mode" button
1.9 Selecting the QAM stage
The output signal QAM stage is selected using the "<" and ">" buttons.
O1 1236 MHz
27.500 MS/s
Outp. S21
6.900 MS/s
Main menu
Select the desired QAM using the "+" and "-" buttons. QAM stages 16, 32, 64, 128 and 256 are available.
If different QAM stages are available, it is advantageous to set the lower stage (e.g. if 256 and 64 are available,
Note:
then select 64). If an exclamation mark "!" is shown beside the output symbol rate (i.e. the input data rate is too
large for the set output data rate), the output symbol rate or the QAM stage must be increased to ensure correct
operation.
All manuals and user guides at all-guides.com
TP
3/4 QPSK
306.00 MHz
256 QAM
displays the sub-menu and pressing the sub-menu button again exits it.
TP
3/4 QPSK
306.00 MHz
256 QAM
(starts mode)
TP
3/4 QPSK
306.00 MHz
QAM
! 32
**
UFO 378TP-O1
Frequency 306.00
Level
Output not lit
"Output channel" sub-menu
to end the mode
7 / 11
**
MHz
0