S&P ECOHAND Manual De Instrucciones página 9

DIRECT CONNECTION TO THE ELECTRICITY NETWORK
• Carefully read the safety warnings listed above before installing the appliance. Ensure that
the power is completely disconnected.
• (Figure 3) Ensure that the power cables have the correct section for the appliance's power
rating. The length of cable protruding from the wall must be at least 40 cm and it must have
a forked terminal to enable the correct connection of the appliance.
• (Figure 1) Remove the water tank (6) using the plastic key supplied (7)
the slot and rotate anti-clockwise, then remove the key and the pin together.
• (Figure 3) Remove the two screws (B) that secure the front cover in place (C). Remove the
front cover of the appliance to gain access to the connection box (D).
• Disconnect the factory installed cable. Insert the power cables through the hole on the
back of the appliance and connect them to the terminal strip as indicated in the diagram.
(Figure 4).
• (Figure 3) Hang the appliance on the support (E) and secure it in place using the two side
screws removed earlier (A). Replace the two plastic caps to cover the screws. Close the
connection box (D) and replace the front cover of the appliance (C) using the corresponding
screws.
IMPORTANT: Before fixing the appliance to the wall, remove the three screws indi-
cated with the arrow (
• (Figure 1) Press the ON/OFF switch (4) and the appliance is ready for use.
INSTRUCTION FOR USE
• (Figure 1) The appliance is equipped with a sensor (8) that lights up the display when it
detects that the bathroom light has been switched on. The same screen indicates how
to insert the hands (10) for drying. The drying timer will begin to count down from 10 to 0
seconds. After a short period of time, the appliance will automatically stop.
MAINTENANCE
• Before carrying out any maintenance task, ensure that the appliance is fully disconnected
from the power supply.
• Flush the water collection circuit with 200 ml of water on a regular basis to ensure that no
foreign bodies are causing a blockage.
• Regularly empty and clean the water tank
never exceed the "full tank" line.
• Regularly remove and clean the air filter with cold water. Ensure that it is completely dry
before replacing it.
• In the event that you need to obtain a replacement filter, please contact our After-Sales Ser-
vice in Spain, or your local distributor in any other country. To find your nearest distributor,
please visit our website www.solerpalau.com
• Regularly clean the housing of the appliance using a damp cloth and cold water.
• Do not use detergents or abrasive products.
) from the back of the appliance.
. The quantity of water in the tank should
9
. Insert the key in