Building Block Video Tx1000/Dc - Dedicated Micros Dennard 2040 Manual

All manuals and user guides at all-guides.com
Move the camera to the desired position.
Press the 'program' key (to bring up the menu display), press key No 1 (to select the programme
preset option) then press the number key you want to use to identify the preset. At this stage the
preset menu from the dome will be displayed on the screen enabling you to key in a preset
identification. Text can be entered by moving the cursor under each letter/number in turn using the
joystick then pressing and holding the 'preset' key, then pressing key number 1 to accept.
When you have finished entering text, close the menu by moving the cursor down to the 'Accept
entry' line and accept by pressing and holding the 'preset' key, then pressing key number 1.
DOME PROGRAMMING:
To access the dome menu:
Press and hold the 'shift' key then press the 'wash' key.
This will give you access to the operator menu. The Supervisor menu and Technicians menu can
be accessed from this point. Holding the 'preset' key, then pressing key number 1 is used to
enter/accept.

6.4 Building Block Video TX1000/DC

Up the coax control
The controller telemetry will output BBV protocols
The Dome address switches need to be set to DEN PANEL
(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on access
to, and setting of, the address switches)
Blue rotary address switch set to F.... Yellow rotary address switch set to D.
This is the default setting for domes unless specified otherwise.
NB If the dome is supplied with a remote protocol converter in the PSU box, then the
address switches will be factory set to: Yellow = 1 Blue = 0
STORING PRESET POSITIONS:
Notes:
In this configuration, it may be quicker to use the controller software rather than using the
Dome software
The Dennard dtx1000 uses on screen menu display which is only available if the monitor is
connected to the keyboard. Simple programming options, like setting a preset position, can
be programmed in without the ability to see the menu display.
Move the camera to the desired position. Press the 'program' key (to bring up the menu display),
press key No 1 (to select the programme preset option) then press the number key you want to use
to identify the preset. At this stage the preset menu from the dome will be displayed on the screen
enabling you to key in a preset identification. Text can be entered by moving the cursor under each
letter/number in turn using the joystick then pressing and holding the 'preset' key, then pressing key
number 1 to accept.
Dennard 2040 / 2060 Menu System Manual Page. 34