Idiomas disponibles
Idiomas disponibles
APS Battery Charger
APS Battery Charger is designed to charge Battery Packs APS2 and APS3 used with digital and thermal
riflescopes, thermal monoculars by Pulsar.
SPECIFICATIONS
SKU
Input voltage,V
Output voltage,V
Mains voltage range, V
Compatible with batteries
Charge/discharge temperature range (RH 60±25%)
Dimensions, mm
Weight, kg
The design, specifications and firmware of this prod-
uct are subject to change for development purposes.
The latest edition of the user manual is available
online at pulsar-vision.com
PACKAGE CONTENTS:
•
APS Battery Charger
•
Mains charger
•
MicroUSB Cable
•
User manual
CHARGING THE BATTERY:
•
Install the rechargeable battery (not included) (1)
along the guides until stop into the charger's (4)
slot.
•
Point А on the battery and point B on the charger
should match.
•
You can charge two batteries at the same time – a
second slot is designed for this purpose.
•
Connect the microUSB plug of the USB cable (7)
into the microUSB port of the mains charger (4).
•
Connect the other microUSB plug of the USB cable
(7) to the jack (5) of the mains charger (3).
•
Plug the mains charger into a socket 100-240V (6).
•
LED indicator (2) will show battery charge status
(see the table).
79165
5
4.2
100-240
APS2/APS3
0 ... 45 °С / -20 ... +60 °С
71x32x31
0.05
А
1
А
B
4
B
5
2
7
6
3
LED indicator*
Battery charge status
Battery charge is from 0 to 10%; Charger is not connected to mains.
Battery charge is from 0 to 10%; Charger is connected to mains.
Battery is defective. Do not use the battery!
Battery charge is from 10 to 20%
Battery charge is from 20 to 60%
Battery charge is from 60 to 95%
Full battery. Remove battery from charger.
* Indication shows the current battery charge level for 30 seconds if the APS charger is not
connected to the mains. Once connected to the mains, indication shows current battery
charge level permanently. LED indicators also glow showing charging process.
SAFETY MEASURES
•
Only use this APS Battery Charger or the charger from the package contents of your device
to charge APS2/APS3 batteries. The use of any other charger may irreparably damage the
Battery Pack or the charger and may cause fire.
•
During long-term storage, the Battery Pack should be partially charged – the charge
level should be between 50% and 80%.
•
Do not charge the battery immediately after bringing the battery from cold environment
to a warm one. Wait for 30-40 minutes for the battery to get warm.
•
Do not leave a battery unattended while charging.
•
Do not leave the Battery Pack with a charger connected to the mains longer than 24 hours
after full charge.
•
Do not expose the battery pack to high temperature or to a naked flame.
•
Do not submerge the battery in water.
•
The Battery Pack is short circuit protected. However, any situation that may cause
short-circuiting should be avoided.
•
Do not dismantle or deform the Battery Pack and Battery Charger.
•
Do not drop or hit the Battery Pack and Battery Charger.
•
When using the battery at negative temperatures, battery's capacity decreases, this is nor-
mal and is not a defect.
•
Keep the battery out of the reach of children.
2
