Installation and connection
1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only.It is not intended for counter-top use or for use
inside a cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide wall-mounted cupboard(at lease 55cm deep
and 85cm off the floor).
5. The appliance is fitted with a plug and must only be connected to a properly installed
earthed socket.
6. The mains voltage must correspond to the voltage specified on the rating plate.
7. The socket must be installed and connecting cable must only be replaced by a qualified
electrician.If the plug is no longer to accessible following installation,an all-pole disconnecting
device must be present on the installation side with a contact gap of at lease 3mm.
8. Adapters,multi-way strips and extension leads must not be used. Overloading can result in
a risk of fire.
The accessible surface may be hot during operation.
Installation Instructions
Please Read the Manual Carefully Before Installation
Please Note Electrical connection
The oven is fitted with a plug and must be only connected to a properly installed earthed socket. In
accordance with the appropriate regulations, the socket must only be installed and the connecting cable
must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation and all-pole isolating switch must be present on the
installation side with a contact gap of at least 3mm.
23
EN