Idiomas disponibles
Idiomas disponibles
V8 Front Fascia Decal Installation
1.
Position the decal to align to the center point of the fascia and tape the
decal into place.
2.
Position three pieces of tape to the outer edges of the decal.
3.
5HPRYH WKH GHFDO IURP WKH IDVFLD SODFH XSVLGH GRZQ RQ D ÀDW VXUIDFH
and gently detach and remove the release liner. Spray surfactant onto the
exposed decal adhesive and the vehicle surface.
4.
Position the decal to align to the tape.
5.
Use the squeegee to press the decal into place.
6.
As the rear edges of the decal extend beyond the edge of the panel, great
care should be taken during premask removal.
7.
Use a towel to carefully dry any surfactant that may remain along the rear
edge of the front fascia panel and underneath the portion of the decal that
extends beyond the panel edge.
8.
Spray the wrapping solution onto the adhesive side of the decal.
9.
Use the heat gun to apply (for 3-5 seconds) direct heat along the length of
the decal.
10. Use a towel to press the decal around the panel edge while applying
additional heat as necessary.
11. Use the squeegee to press the decal into place.
12. Apply additional heat (as necessary) and press into place until the decal is
properly adhered.
V8 Hood Decal Installation
1.
/D\ WKH /+ GHFDO XSVLGH GRZQ RQ D ÀDW VXUIDFH DQG JHQWO\ GHWDFK DQG UHPRYH
the release liner from the decal.
2.
Spray a generous amount of surfactant onto the exposed decal adhesive and
the vehicle surface.
3.
Position the premask carrier of the decal to align to the edges of the extractor
panel, to the rear edge of the panel and to the previously installed front fascia
decal.
4.
Use a squeegee to press the decal into place.
5.
Remove the premask.
6.
For the RH decal, use the same steps as shown for the LH decal.
RALLY Stripes
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
AUTH
REVISION
V6 (ONLY) HOOD TEMPLATE
PART NO.
IR 21FE14
INSTALLATION INSTRUCTIONS
DR
TITLE
PART NO.
23432805
Rear Edge of Hood Panel
100mm (approx. 4")
23432805
SHEET
RALLY Stripes
4
SHEET
4
14
OF
14
OF
