Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
CONNECTION
The amplifier and all system components should be disconnected from the power supply before making any
connections.
Connect microphone or line-level sound sources via INPUT 1 to INPUT 6, ensuring that input gain is regulated.
If a condenser microphone is connected, select phantom power (48 V) on the rear panel of the amplifier.
If your system consists of M-62, microphones, connect these via the REMOTE MIC port. The maximum
number of M-62 microphones is 6 with 2 cascade connections (3 + 3).
Use the 4 Ω low impedance output or the 100 or 70 V high impedance line output, depending on the type of
speakers you are connecting. Do not use both output types at the same time.
To connect low-impedance speakers, you must make serial/parallel connections so that the load impedance
of the speakers equals the output impedance of the amplifier and the power supplied by the amplifier does
not exceed the power supported by the speakers.
To connect 100V line speakers, you must make parallel connections. The MPZ-6241 amplifier has several
100V line output zones with independent volume control.
NOTE: The maximum power of each zone is 50 W RMS and the total sum of the power of all speakers must
not exceed the maximum power supplied by the amplifier, 240 W RMS.
Once the connections have been made according to your needs, connect the devices to the power outlet
and turn them on. After use, do not forget to turn off and disconnect the appliance from the power outlet.
- 6 -
Tabla de contenido
